EZ-CASEª SYSTEM

CORNER CASTER FOR NCASE 2 SYSTEMS - ALUMINUM WITH BLACK LAQUER FINISH. CAPACITY OF 110 POUNDS PER WHEEL  SOLD INDIVIDUALLY 

.These interlocking corner braces create a seamless transition between the tongue and groove extrusion and the corner brace, effectively eliminating the need for costly miter cutting.For use with E082571 9mm / 3/8” Hybrid Extrusion.

Hybrid Corner for use on deep lid section of case.   Corners used with this product.    Hybrid Base Corner NC2HCBK  . Basemaker Corner NC2LC54K . Hybrid Lid Corner NC2HCLK ...

Our Medium Surface Twist Latch provides for a secure closure without recessed cutouts being required. Rivets Required For Installation: 5Rivets may require backing washers depending on your case design and method of installation. Any rivets...

Our Draw Latch provides for a secure closure without recessed cutouts being required. Rivets Required For Installation: 5Rivets may require backing washers depending on your case design and method of installation. Any rivets inserting through...

Our Locking Draw Latch provides for a secure closure without recessed cutouts being required. Rivets Required For Installation: 5Rivets may require backing washers depending on your case design and method of installation. Any rivets inserting...

Our Heavy Duty Die Cast Draw Latch provides for a heavy duty secure closure without recessed cutouts being required. Rivets Required For Installation: 4 OUR RIVETS DO NOT FIT THESE HOLES - SMALLER DIAMETER RIVETS MUST BE PURCHASED AT YOUR LOCAL...

Standard heavy-duty black attache surface handle. This is a one-piece assembly that mounts to the exterior case surface without requiring any cutout and allows for comfortable carrying of cases.  Rivets Required...

Standard heavy-duty black leather look strap surface handle. This handle for more elegant applications is a one-piece assembly that mounts to the exterior case surface without requiring any cutout and allows for...

Standard heavy-duty designer black rubber surface handle. This handle for more elegant applications is a one-piece assembly that mounts to the exterior case surface without requiring any cutout and allows for...

Heavy-duty surface-mount pull-out handle. This is a 3-stage surface-mounted telescoping pull-out handle used for tilt-and-roll case applications and allows for comfortable movement of such cases. Pull-out extends up to 22". Rivets or...

Take-apart Hinge For Hinged Lids That You May Want To Remove - This large take-apart hinge may be utilized in place of our continuous hinge in order to create a hinged lift-off lid without the expense of adding 2 additional twist latches. This hinge...

Hinge For Hinged Lids - This hinge easily creates hinge lids for your caseRivets Required For Installation: 6Depending on your case design and dimensions, some rivets may require backing washers. Some rivets will install through the...

Small Strut Hinge Lid Stay - This surface-mount lid stay has a built-in hinge. May be used as a stand-alone hinge (in pairs, or three at a time) on small cases in place of a standard hinge. Or it may be used in conjunction with other hinges...

Surface Edge Caster - This edge caster is a great alternative when you don't need our mega-duty recessed edge or corner casters - especially if you want to create a tilt-and-roll scenario with an existing case without cutting through your extrusions...

Light Duty Edge Caster - This luggage-style caster with skid runner is suited for small lightweight cases (similar to carry-on luggage). These are not meant for road/flight cases.Material: High-impact plastic